Xerox WorkCentre Pro 75 Panduan Instalasi Jaringan - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Instalasi Jaringan untuk Mesin fotokopi Xerox WorkCentre Pro 75. Xerox WorkCentre Pro 75 42 halaman. Pdl reference guide
Juga untuk Xerox WorkCentre Pro 75: Panduan Memulai Cepat (16 halaman), Panduan Pengguna (24 halaman), Panduan Administrasi Sistem (30 halaman), Panduan Referensi (22 halaman)
Halaman Cetak
Dynamic TCP/IP Address Assignment (DHCP/BOOTP/RARP)
To enter a Subnet Mask and Gateway
Address...
NOTE: The printer will only accept one Gateway
address from a DHCP server.
9.
Press the Subnet and Gateway button.
a) Press the soft buttons on the Touch Screen
one at a time for each octet of the Subnet
Mask and enter the numbers using the
keypad.
b)
Repeat the process for the IP Gateway
address. When finished press Save to
record the changes and exit to the TCP/IP
Settings screen.
c) Press the Close button.
To enable LP and LPR printing
10.
Press the TCP/IP - Line Printer button. At the
next screen press the Enable button.
NOTE: While you can change the port number at
which your printer will accept lpr print jobs it is
recommended that you do this ONLY with extreme
caution as most lpr spoolers are set to send print jobs
to the default port.
a) If you wish to change the lpr port for your
printer press the port number soft button
and enter the desired port number at the
keypad. Press Save.
NOTE: Your printer will not reboot unless you have
changed a physical media setting.
11.
Enable HTTP/IPP
a) Press the HTTP/IPP button. At the next
screen press the Enable button. Then press
Save.
b) Press the Close button three times.
12.
Print a Configuration Report page and verify
the TCP/IP information was assigned correctly.
Repeat steps 7b - 7f
Note: Update the lease time (if necessary) at the
DHCP/BOOTP server depending on your printer
usage patterns. Consult your DHCP server
documentation for details.
604P14900
Note: If your RARP Server does not dynamically update
its /etc/ethers and /etc/hosts fields with a host name, you
will need to do this manually. Consult your RARP or
BOOTP server documentation for details.
Where to go from here
After you have verified that the TCP/IP information you
have assigned to your printer is correct, retrieve the
Quick Install Card that applies to your network operating
system or protocol and perform the procedures
indicated.
Now that the TCP/IP information has been provided, you
are able to print via a Web Browser (HTTP), an IPP
capable operating system, or to TCP/IP Port 9100. For
further information, please reference Microsoft
Windows 2000 LPR and IPP Printing Quick Install
and Port 9100 TCP/IP Printing Quick Install Cards.
16