Xerox 8560N - Phaser Color Solid Ink Printer Panduan Tambahan - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Tambahan untuk Aksesori Printer Xerox 8560N - Phaser Color Solid Ink Printer. Xerox 8560N - Phaser Color Solid Ink Printer 26 halaman. Phaser 8560 series
Juga untuk Xerox 8560N - Phaser Color Solid Ink Printer: Panduan Tambahan (10 halaman), Panduan Penggunaan Cepat (5 halaman), Surat Volatilitas (1 halaman), Panduan Instalasi (2 halaman), Lembar Instruksi (2 halaman), Panduan Evaluator (20 halaman)

Halaman Cetak
Xerox 8560N - Phaser Color Solid Ink Printer Panduan Tambahan
2. Close the document feeder.
3. On the control panel, select
calibration page.
4. Wait for the scan to be completed, and then select one of the following options:
■
If the control panel indicates
■
If the control panel indicates
5. Remove the Scanner Calibration page from the document glass.
■
If you have a document feeder, continue with the steps in the Document Feeder section.
■
If you have a document glass cover, you have completed scanner calibration.
Document Feeder
1. Place the Scanner Calibration page in the document feeder, so that the top edge of the page enters the
feeder first. Adjust the paper guides to fit against the page.
Note: Make sure the Scanner Calibration page is aligned correctly and the paper guides are adjusted to
fit against the paper. If the page is misaligned, the calibration procedure will fail.
2. On the control panel, select
calibration page.
3. Wait for the scan to be completed, and then select one of the following options:
■
If the control panel indicates
complete.
■
If the control panel indicates
Note: For more information about calibrating the scanner, see the Knowledge Base at
www.xerox.com/office/8510_8560support.
Copyright © 2006, by Xerox Corporaton. All Rights Reserved.
, and then press the OK button to scan the
Document Glass Step
, press the OK button, and then continue with Step 5.
Success
, press the OK button, and then repeat Steps 1–4.
Failure
Document Feeder Step
, press the OK button. The calibration procedure is
Success
, press the OK button, and then repeat Steps 1–3.
Failure
, and then press the OK button to scan the
www.xerox.com/office/8510_8560support
2 of 2
LTR/LGL
075-1018-00 Rev A