Xerox Fiery EX12 Color server Panduan Memulai Cepat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Aksesori Printer Xerox Fiery EX12 Color server. Xerox Fiery EX12 Color server 8 halaman. Color server
Juga untuk Xerox Fiery EX12 Color server: Panduan Memulai Cepat (5 halaman)

Halaman Cetak

Xerox Fiery EX12 Color server Panduan Memulai Cepat

4 Quick Start Guide

UNIX (TCP/IP) workstation

IPX (Novell) network

Preparing to print

To set up your Fiery, you must perform the following tasks:

• Connect the Fiery physically to a functioning network.

• Conﬁgure the network server.

• Set up the Fiery from the Control Panel.

• Prepare client workstations for printing.

A brief explanation of each task follows.

Connecting the Fiery to a functioning network

already installed a network cabling system and has connected workstations and servers. For

examples of different networks, see the

• Prepare a network node for the Fiery.

• Route the cable to a location near the copier where the Fiery will be installed and attach

• Connect the Fiery to the copier and print a test page.

O PREPARE FOR

1. Print a copier test page to verify the copier is functioning normally.

2. Turn off the copier and connect the interface cable from the copier to the Fiery.

3. To conﬁrm this connection, turn on the copier and the Fiery and print a Test Page from the

Fiery Control Panel.

To print a Test Page, press the Menu button on the Control Panel to access the Functions

menu. Choose Print Pages, and then choose Test Page.

4. With both the copier and the Fiery turned off, connect the network cable to the Fiery.

The network should already be installed and operational.

5. Turn on the copier and then the Fiery.

Other Network Requirements

• Standard TCP/IP connectivity (for example, Sun SPARCStation or Silicon Graphics

workstation with Solaris version 2.5 or later or SunOS version 4.1.x software)

• TCP/IP printing software that conforms to RFC1179 (Berkeley lpd protocol)

• Novell server

• Novell NetWare software version 3.x, 4.x, or 5.x

• Support for Ethernet SNAP, Ethernet II, Ethernet 802.3, and Ethernet 802.2 frame types

When you add the Fiery to a network, it is assumed that a network administrator has

OTE

the cable to the network interface of the Fiery.

For more information, see Chapter 1 of the

For detailed instructions, see the

IERY CONFIGURATION

Conﬁguration Guide

Part Number: 45025694