Xerox PHASER 5400 Panduan Pemasangan Cepat - Halaman 36
Jelajahi secara online atau unduh pdf Panduan Pemasangan Cepat untuk Aksesori Printer Xerox PHASER 5400. Xerox PHASER 5400 40 halaman. 1000-sheet stacker
Juga untuk Xerox PHASER 5400: Petunjuk Teknis (5 halaman), Manual (11 halaman), Petunjuk Instalasi (2 halaman), Manual Kertas (2 halaman)
Halaman Cetak
Dynamic addressing (RARP/BOOTP)
The TCP/IP address is assigned automatically by the Server. Follow
the steps below:
Press Menu Up or Menu Down until you see:
1.
Menus
Ethernet Menu
2.
Press Item Up or Item Down until you see:
Ethernet Menu
IP Address Res.
3.
Press Value Up or Value Down until you see:
IP Address Res.
BOOTP/RARP
Press Enter.
4.
5.
Update the RARP/BOOTP server's /etc/bootptab files with the
printer's hardware and IP address. In order to communicate with
the printer using the hostname rather than the IP address, update
the /etc/hosts file with the printer's IP address and hostname (IP
hostname from the configuration sheet).You can also update the
/etc/ethers file using the printer's hardware address and
hostname.
6.
Power off the Printer.
7.
Power the printer on and allow time for an IP address to be
assigned by the RARP/BOOTP server (this time may vary
depending on network traffic).
8.
Perform the steps contained in the section of this document
entitled Appendix A: Print the Configuration Sheet.
9.
Obtain the TCP/IP address from the Configuration Sheet.
30
Xerox Phaser 5400 Laser Printer