Xerox 6180DN - Phaser Color Laser Printer Manual - Halaman 33

Jelajahi secara online atau unduh pdf Manual untuk Perangkat lunak Xerox 6180DN - Phaser Color Laser Printer. Xerox 6180DN - Phaser Color Laser Printer 34 halaman. 26-ppm monochrome/ 20-ppm color
Juga untuk Xerox 6180DN - Phaser Color Laser Printer: Panduan Instalasi (34 halaman), Lembar Spesifikasi (2 halaman), Panduan Pengguna (32 halaman), Panduan Pengguna (28 halaman), Instal Manual (2 halaman), Manual Keamanan (38 halaman), Catatan Rilis (2 halaman), Instal Manual (2 halaman), Panduan Memulai (37 halaman), Manual (34 halaman), Panduan Memulai (34 halaman), Panduan Pengguna (32 halaman), Panduan Instalasi dan Pengoperasian (8 halaman), Spesifikasi (4 halaman), Manual (28 halaman)

DocuSP 3.6 to 3.7 Differences Document

limited by the available hard disk space. The entire job must

be spooled to disk before the decomposer can begin ripping.

Auto End changes and moves

¨ In previous versions, the operator needed to press "Start" to

start an online job and press "End" to finish the job. The

operator needed to be present to press "End" so that network

jobs could be scheduled and printed.

¨ The AutoEnd feature allows:

¨ Online jobs to automatically end and start based on a timer

set in the Online Gateway configuration.

¨ Online jobs automatically end and start based on the receipt

of the channel command 0x6b (raise cover) in the

datastream.

¨ Now the AutoEnd feature invokes the "End" for the current

job and starts a new job without operator intervention.

¨ The System Administrator enables AutoEnd. By default, the

AutoEnd feature is disabled.

¨ AutoEnd is supported in both streaming and spooling modes.

¨ AutoEnd and AutoDrain with a timer cannot be set at the

same time.

¨ A popup message prompting the operator to save the current

job setup will no longer display when an operator exits online

manager.

¨ To save a job setup to a file, the operator will have to select

the Save or Save As button in the online manager window.

¨ Image shift is supported for LCDS jobs on the DocuPrint

75/90 and on DocuPrint 1xx EPS printers.

¨ Image shift changes must be applied before the job is sent.

Any changes made while a job is printing are not honored

until the next job.

¨ If the operator shifts the image too far in a negative direction,

the image may be cropped.

¨ The Aux, Main, and Auto stock definitions are available in the

Stock Library and cannot be deleted from the system.