Xerox 6180N - Phaser Color Laser Printer Panduan Memulai - Halaman 31

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Perangkat lunak Xerox 6180N - Phaser Color Laser Printer. Xerox 6180N - Phaser Color Laser Printer 37 halaman. Color laser printer
Juga untuk Xerox 6180N - Phaser Color Laser Printer: Panduan Instalasi (34 halaman), Lembar Spesifikasi (2 halaman), Panduan Pengguna (32 halaman), Panduan Pengguna (28 halaman), Instal Manual (2 halaman), Manual Keamanan (38 halaman), Catatan Rilis (2 halaman), Instal Manual (2 halaman), Manual (34 halaman), Manual (34 halaman), Panduan Memulai (34 halaman), Panduan Pengguna (32 halaman), Panduan Instalasi dan Pengoperasian (8 halaman), Panduan Evaluator (16 halaman), Spesifikasi (4 halaman)

Nuvera Stacker/Finisher Script

XEROX DOCUMENT SERVICES PLATFORM SERIES

GETTING STARTED

For the Nuvera family of printers, you must use the following

script to set up Stackers and/or Finishers:

1. Open a terminal window.

2. Login as root.

3. Type cd /opt/XRXnps/bin/DFA_IsStacker.

4. Press <Enter>.

5. Type ./set –f 0 OR ./set –f 1. Use the value 0 if the

attached DFA device is a finisher, or use the value of 1 if

the attached DFA device is a stacker. Note that there are

spaces before and after the –f switch.

6. Restart DocuSP.

NOTE: This setting is lost on an upgrade or a scrape

install and must be recreated using this procedure.

Prior to DocuSP 4.0, the controller applied the LPR gateway

filename to submitted documents as opposed to the internally

set document name. Starting with DocuSP 4.0, the controller

applies the internal document name to the job.

To set the DocuSP to the pre-4.0 behavior, run the following

script:

1. Open a terminal window.

2. Login as root.

3. Type enablePre40LPRBehavior

4. Press <Enter>.

5. To disable the pre-4.0 LPR behavior, type

disablePre40LPRBehavior

6. Restart DocuSP.

NOTE: A document name set in the job ticket has a higher

precedence than the LPR gateway and internal document

attributes.

DOCUSP 4.1