Xerox 850DX - Phaser Color Solid Ink Printer Catatan Rilis - Halaman 15

Jelajahi secara online atau unduh pdf Catatan Rilis untuk Perangkat lunak Xerox 850DX - Phaser Color Solid Ink Printer. Xerox 850DX - Phaser Color Solid Ink Printer 33 halaman. Installation guide for accxes 10.2
Juga untuk Xerox 850DX - Phaser Color Solid Ink Printer: Spesifikasi (2 halaman), Panduan Operator (16 halaman), Panduan Tambahan (1 halaman), Panduan Tambahan (11 halaman), Setup Manual (1 halaman), Panduan Petunjuk Pembersihan (9 halaman), Panduan Tambahan (26 halaman), Catatan Rilis (11 halaman), Catatan Rilis (11 halaman), Petunjuk Instalasi (2 halaman)

8.1.1.3

USING ON DEMAND IMAGE OVERWRITE (ODIO)

The On Demand Image Overwrite (ODIO) feature is designed to clean the system after it has

been used by overwriting the entire HDD and is activated by pressing the "Start" button on the

Security Feature Web Pages shown below. After pressing the "Start" button, the AccXES

controller will post a message to the Printer UI display (if there is one) and then reboot. The HFT

and PUN controllers will indicate the progress of the operation via the LED's on the front panel.

The printer UI on the 510, 8850, 8830, and 8825 will also display progress. The WebPMT and

scanner UI will NOT be active until the operation is complete.

When the ODIO operation is complete, the controller will print a status page and then resume

normal operation.

An ODIO is a lengthy operation. Approximates times for an ODIO are listed in the table below:

HDD

Size

20GB

40GB

80GB

NOTE: If you have done an ODIO, it is important that you do NOT refresh the Web page after the

system reboots because the refresh will resend the "ODIO Request" and cause the system to

perform another ODIO.

Page 15

Controller Type

HFT/PUN

30 Minutes

45 Minutes

90 Minutes