Xerox 850N - Phaser Color Solid Ink Printer Panduan Operator - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Operator untuk Perangkat lunak Xerox 850N - Phaser Color Solid Ink Printer. Xerox 850N - Phaser Color Solid Ink Printer 16 halaman. Installation guide for accxes 10.2
Juga untuk Xerox 850N - Phaser Color Solid Ink Printer: Spesifikasi (2 halaman), Panduan Tambahan (1 halaman), Panduan Tambahan (11 halaman), Setup Manual (1 halaman), Panduan Petunjuk Pembersihan (9 halaman), Panduan Peningkatan (8 halaman), Panduan Tambahan (26 halaman), Catatan Rilis (33 halaman), Catatan Rilis (11 halaman), Catatan Rilis (11 halaman), Petunjuk Instalasi (2 halaman)

Stacker operation

The stacker is "switched on" by connecting the power cord to

the power outlet.

There is no power switch. The power cord is the on/off

switch.

Once the power cord is connected to the power outlet, the

stacker motor drive and fan initialize.

As media leaves the printer, the lead edge of the media enters

the stacker. A motion sensor in the stacker detects the lead

edge of the media and the fan and motor are switched on. The

media then is fed into the stacker inclined tray.

When the motion sensor detects the trail edge of the media, the

fan and motor continue to run until the print is fed into the

inclined tray. After the last print output is fed into the stacker

tray, the fan and motor switch off.

Stacker 1000 Operator Manual

Stacker overview

The Stacker 1000 is equipped with tray extensions:

Tray

extensions

These tray extensions are used for E-size (A0) and longer-size

prints.