Xerox AccXES 10.2 Petunjuk Instalasi

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Perangkat lunak Xerox AccXES 10.2. Xerox AccXES 10.2 2 halaman. Installation guide for accxes 10.2

Halaman Cetak

AccXES Version 10.2 Installation Instructions

Warning: If you have an HFT controller with AccXES 8.0 or 8.5, upgrading to AccXES 9.0 will

cause you to lose the following Data Format Interpreters (DFI):

• VCGL

• Versatec Raster (VRF & VDS)

• CGM

These DFIs are no longer part of the standard system. A feature key is necessary to enable them.

The DFI Feature Keys can be purchased through Xerox Sales or an Authorized Reseller. See Step

1 to determine if you have the appropriate controller.

Note: For the Xerox 6050 and 6030 Wide Format products, one must activate the AccXES print server by

downloading the appropriate print server feature

Warning: If the current AccXES Version is 8.0 or lower, upgrading to AccXES 9.0 will eliminate all existing

feature keys. Once installation is complete, you will need to reinstall your feature keys. If you are currently

at AccXES 9.0 or greater, your feature keys will be retained.

Step 1

Determine your Hardware Configuration

There are distinct versions of firmware for each controller hardware platform. Firmware is available for the

hardware platforms as indicated below. Your hardware platform can be determined by examining the

printer configuration test print or serial number (found on the AccXES controller unit). Note your hardware

version. Note: Use the HFT firmware as this will be the correct downloadable binary for PUN controllers.

Controller

PUN

HFT

CNG

KLF

N5T

EV4

Step 2

Release Notes

Download, print, and read the AccXES release notes (pdf format). The release notes can be found in the

documentation section or by using the 'See Also' link.

Step 3

Check Disk Size and RAM Requirements

Consult the Recommended Configurations Chart in the AccXES Release Notes to confirm that your

Controller has the required disk size and RAM needed for the AccXES upgrade. This chart can be found in

the documentation section or by using the 'See Also' link.

Step 4

Job Accounting Migration (if applicable)

Warning: As a precaution, save your Job Accounting Data prior to upgrading. If you have AccXES 7.5 or

greater and are using Job Accounting, use the Account Management Tool (AMT) to collect existing Job

Based Accounting Data from the AccXES Controller / Printer. If you have AccXES 6.1 or lower and are using

job accounting, please read the Job Accounting Migration document (found in the Documentation section)

which describes the migration process from the legacy accounting system to the new Job Based Accounting

system. Legacy Job Log files are deleted when upgrading to AccXES 7.5 or greater. Use the Web Printer

Manager Tool, Scanner UI or ACT to retrieve/store your legacy data prior to upgrading AccXES.

key.

CPU from Test Print

RTT-MPC 7410

PPC740 – 200

MPC8240-250

Serial Number

PUN-XXXXX

HFT-XXXXX

CNG-XXXXX

KLF-XXXXX

N5T-XXXXX

EV4-XXXXX