Xerox Nuvera 100 Manual Perencanaan - Halaman 30

Jelajahi secara online atau unduh pdf Manual Perencanaan untuk Perangkat lunak Xerox Nuvera 100. Xerox Nuvera 100 38 halaman. Production system
Juga untuk Xerox Nuvera 100: Lembar Spesifikasi (2 halaman), Panduan Fitur (34 halaman), Manual Perencanaan (22 halaman), Panduan Pengguna (40 halaman), Panduan Pengoperasian (34 halaman), Panduan Referensi (2 halaman), Manual Perencanaan (20 halaman), Panduan Referensi (42 halaman), Referensi Cepat (2 halaman), Instal Manual (2 halaman), Panduan Tambahan (48 halaman), Manual Perencanaan (16 halaman), Panduan Referensi (2 halaman), Spesifikasi (2 halaman), Panduan Petunjuk dan Tips (18 halaman), Panduan Petunjuk dan Tips (18 halaman), Panduan Memulai (26 halaman), Panduan Memulai (30 halaman)

Halaman Cetak
Xerox Nuvera 100 Manual Perencanaan
C.P. Bourg Document Finisher (BDFx)

Limitations

System Dependencies and Prerequisites

Configuration Guide

Printer Configurations
FEEDER
FEEDER
PRINT
ENGINE
The diagram above is only an example. The
Xerox iGen3 Digital Production Press can have
the following configurations:
•
Up to 6 Feeders
•
1 inserter
•
Up to 4 Stackers
•
The BDFx can only be guaranteed to work to its maximum
book thickness when feeding (8.5 x 11 / A4) paper if the
paperweight is 90 gsm or less. (Long grain paper with a
weight above 90 gsm should be tested with the customer
paper and application before selling the BDFx.)
•
Use of short grain paper is highly recommended for 11 x 17"
/ A3 sized paper.
•
The BCFx is not an available option together with the iGen3.
•
The Cover Page of the booklet must be sent as the last page
in the set.
•
If installing a new Book Factory on an existing iGen3
installation, a Xerox iGen3 Finishing Interface kit (product
code UYR) must be ordered.
•
The BSR is mandatory when a BDFx is installed inline with
iGen3. (The BSR is equipped with an enhanced static
elimination transport (Tag 21) that greatly reduces static on
papers delivered from the iGen3).
•
Transition of an existing BSR to an iGen3 is not possible
unless Tag 21 is already installed.
The Configuration Guide contains diagrams over the various
Finishing Solutions that are currently supported.
OUTPUT
INSERTER
STACKER
MODULE
5-2
Finisher Configurations
STACKER
BSR
BDFx
BSR
BDFx
SQEDG