PostScript Utility files can be used on hosts that do not have BOOTP or DHCP— see the ReadMe
file on the Printer Installer and Utilities CD-ROM. The PC ReadMe file is in the UTILS
directory of the Printer Installer and Utilities CD-ROM; the Macintosh ReadMe file is in the
Network Utilities folder.
Note
When two or more IP address methods are used simultaneously, the printer uses the first
address that it successfully obtains.
Information Required for IP Addressing
Information
Internet (IP) address for the printer
Network Mask
Default Router/Gateway address
Setting the IP address from the front panel
For information about using the front panel, refer to the Front Panel section of the Features Guide on
the Interactive Documentation CD-ROM.
Note
DHCP must be set to OFF before you can set the IP address from the printer's front panel.
1.
With
highlighted, press the OK key.
Menus
2.
Press the Down Arrow key to scroll to the
3.
Scroll to
TCP/IP Address Menu
4.
Scroll to
TCP/IP Address
5.
Verify the number of characters in the IP address. There should be 12 characters. IP addresses are
entered in xxx.xxx.xxx.xxx format, where each segment represents a number from 0-255.
6.
By pressing the Up Arrow or Down Arrow key, scroll to the correct number for the first segment
of the address. Press the OK key to accept that segment.
7.
Repeat Step 6 for each remaining segment.
8.
Scroll to
TCP/IP Network Mask
9.
By pressing the Up Arrow or Down Arrow key, scroll to the correct number for the first segment
of the address. Press the OK key to accept that segment.
10.
Repeat Step 9 for each remaining segment.
11.
Scroll to
TCP/IP Gateway
12.
Scroll to the correct number for the first segment of the address by pressing the Up Arrow or
Down Arrow key. Press the OK key to accept that segment.
13.
Repeat Step 12 for each remaining segment.
14.
To exit the menu system, scroll to
Phaser® 7300 Color Printer
Comments
Format is xxx.xxx.xxx.xxx, where xxx represents a decimal number
from 0 - 255.
If you are unsure, leave this blank; the printer chooses an
appropriate mask.
If you want to communicate with the printer from anywhere other
than the local network segment, you need the router address.
Connection Setup Menu
by pressing the Down Arrow key and press the OK key.
by pressing the Up Arrow or Down Arrow key. Press the OK key.
by pressing the Up Arrow or Down Arrow key.
by pressing the Up Arrow or Down Arrow key.
and press the OK key.
Exit
IP Address
and press the OK key.
2
Halaman Cetak