Xerox Phaser 7760 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat lunak Xerox Phaser 7760. Xerox Phaser 7760 35 halaman. Color laser printer
Juga untuk Xerox Phaser 7760: Fitur (1 halaman), Panduan Evaluator (20 halaman), Panduan Tambahan (16 halaman), Setup Manual (2 halaman), Panduan Referensi Cepat (5 halaman), Panduan Evaluator (20 halaman), Lembar Instruksi (6 halaman), Lembar Instruksi (14 halaman), Panduan Evaluator (21 halaman), Panduan Evaluator (18 halaman), Perbandingan Kompetitif (2 halaman), Perbandingan Kompetitif (1 halaman), Panduan Servis (16 halaman)

Halaman Cetak
Xerox Phaser 7760 Panduan Pengguna

Installing on Windows Systems

1.
Insert the PhaserMatch or PhaserCal CD-ROM into your computer's CD-ROM drive.
The CD-ROM automatically runs the installer.
2.
Read the license agreement and click Accept to continue.
Note:
To install additional profiles, select Custom, and then select the profiles that you
want to install.
3.
Follow the prompts in the installer to finish the installation.

Next Recommended Reading

■
For an introduction to using PhaserMatch or PhaserCal to calibrate your Phaser 7760,
7750, or 7700 printer, go to
■
For an introduction to creating a custom TekColor correction, go to
TekColor Corrections
■
For an introduction to printing using custom TekColor corrections, go to
Custom TekColor Corrections

Typical Uses of PhaserMatch Software

Calibrating a Printer

Color calibration is one of the most important things you can do if you want to obtain optimal
color output from your printer. Color laser printers must be periodically calibrated to eliminate
changes in printed colors caused by environmental conditions, such as temperature and
humidity, and normal wear on printer consumables, such as toner cartridges and imaging units.
Calibration may also be necessary if the printer has been used for long extended print runs or
after extended periods of inactivity.
Calibration can be done using one of the following two methods.
■
Method 1 is a spectrophotometer-based calibration done within PhaserMatch/PhaserCal
software.
This is the recommended method for calibration as it provides the most consistent
calibration method for your printer. If you do not have a spectrophotometer, it is suggested
that you consider purchasing one because a spectrophotometer can be a valuable color tool
for your business.
■
Method 2 is a visual calibration done using the control panel of the printer.
Calibration should be performed after the printer is warmed up.
For more information on color calibration, see
Calibrating a Printer
on page 1-4.
on page 1-6.
Printer Calibration
PhaserMatch and PhaserCal 4.0 User Guide
1-3
Typical Uses of PhaserMatch Software
on page 1-3.
Creating Custom
Printing with
on page 2-1.