Xerox Synergix 8830 Panduan Operator - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Operator untuk Perangkat lunak Xerox Synergix 8830. Xerox Synergix 8830 48 halaman. Windows nt 4.0 postscript print driver user guide
Juga untuk Xerox Synergix 8830: Setup Manual (20 halaman), Catatan Rilis (23 halaman), Panduan Tambahan (26 halaman), Manual Perangkat Lunak (30 halaman)

Halaman Cetak

POWER ON/OFF

Power Saver, Rest Modes

POWER SAVER MODE

POWER. PRESS [ENTER] TO WARM UP PRINTER

The printer will go through two stages of power conservation after a

preprogrammed time interval of no print activity or control panel activity:

1) POWER SAVER MODE

Using the printer menu, you can adjust the time interval that the printer remains

in the Ready mode from 5 to 50 minutes. After this preset interval, the printer

will enter the Power Saver mode. Refer to the Off Line Menus section of this

manual for instructions.

FUSER IS AT LOW

XES Synergix 8825/8830 Printer Operator Manual

REST MODE

PRESS [ENTER] TO WARM UP PRINTER.

2) REST MODE

In the Rest mode, a minimum of power is supplied to the printer.

Using the printer menu, you can adjust the time interval that the printer

remains in the Power Saver mode from 15 to 150 minutes. After this preset

interval, the printer will enter the Rest mode. Refer to the Off Line Menus

section of this manual for instructions.

A print request returns the printer to the on-line mode.

FUSER IS OFF