Xerox Workcentre 265 Panduan Tambahan - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Tambahan untuk Perangkat lunak Xerox Workcentre 265. Xerox Workcentre 265 20 halaman. Xerox multifunction printers specification
Juga untuk Xerox Workcentre 265: Panduan Referensi (27 halaman), Instal Manual (2 halaman), Spesifikasi (21 halaman), Panduan Evaluator (27 halaman), Panduan Cepat (21 halaman)

Halaman Cetak

Setup

This chapter describes:

– how to load tab stock into the paper trays

– how to create tab masters

Loading tab stock into the paper trays

This procedure is the same for both copying and printing onto tab stock.

Note:

– tab stock can be loaded into either the Bypass Tray, Tray 1 or Tray 2.

– The stock you are using for the body of the document should be loaded into

– The tab stock and the body stock MUST be the same size and orientation.

Bypass Tray

Load the tab stock into the bypass tray as

follows:

a) Tabs to the left with tab 1 on top and at

b) Tabs in standard order. If more than

Move the rear guide against the rear edge

of the tab stock.

Xerox CopyCentre, WorkCentre, WorkCentre Pro 232/238/245/255/265/275 Tab Supplement

Trays 3 or 4.

Use 8.5 x 11 inch paper with 9 x 11 inch tab stock or A4 paper with A4 tab

stock in the same orientation.

the front of the tray

one set of tabs is required, the number

and sequence of the tabs loaded must

match the number and sequence of

tabs to be printed. Any surplus tabs

should be removed from each set prior

to starting the job.