eControls WT3 Panduan Pemilik Rumah dan Pemasang - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik Rumah dan Pemasang untuk Pengatur waktu eControls WT3. eControls WT3 8 halaman. Wall timer control kit

Halaman Cetak

Wall Anchor

Cutout for WT3.

Drill and install wall anchors

before cutting WT3

access hole.

Wall Anchor

Power the WHF and Set Fan Speeds

Make sure the following have been completed before powering the WHF.

FC3JU is wired and installed in electrical box on WHF. Ensure wiring is correct for fan type and speed.

FC3JU is connected to WT3 using the supplied plug & play cable.

The WT3 is compatible with 1, 2 and 3-speed PSC and

ECM WHFs. The WT3 is shipped set for a 2-speed

WHF.

To change the number of speeds, PRESS and HOLD

both the TIMER and the SPEED SWITCHES at the

same time. The LEDs will turn off and the right LED (8-

Hour) will rapidly blink once, pause and then rapidly

blink twice, pause and then rapidly blink three times

while both switches are pressed.

Releasing the switches after one blink sets the WT3 for

single speed (High) operation. Releasing after two

blinks sets the WT3 for 2-speed (High and Low)

operation and releasing after 3 blinks sets the WT3 for

3-speed (High, Med and Low) operation.

INSTALLATION

Use the template to mark the center of the wall

anchor holes and the corners of the cutout. Score

the drywall with a utility knife.

Drill the holes for the wall anchors and install the

wall anchors. Use a drywall saw to remove the

cutout.

Plug the cable into the connector on the WT3, insert

the WT3 into the openning and secure with the two

screws.

To set the number of fan

speeds, PRESS and

HOLD both the TIMER

and SPEED SWITCH at

the same time.

Smart

MED

TIMER - ON - OFF

SPEED

WHF