Yamaha disklavier DS4M4 PRO Buku Panduan Pemeliharaan - Halaman 20

Jelajahi secara online atau unduh pdf Buku Panduan Pemeliharaan untuk Alat Musik Yamaha disklavier DS4M4 PRO. Yamaha disklavier DS4M4 PRO 36 halaman.

5. MKIV/Pro installation manual

5 - 12 - 3. PRC100 rebooting, resetting and pairing

Rebooting or resetting will be more effective

HINT!

countermeasure than Mark III systems

Rebooting the Pocket Controller

1) Tap on

on the task bar.

2) Tap on [Reboot]

on the menu that appears.

3) Tap on [Yes].The [Main] screen appears after approxi-

mately three minutes.

In case you change the PRC100 to a new one for some reason, you need to pair the new PRC100 and

Disklavier as follows:

Pairing the Pocket Controller and the Disklavier

For normal use, this setup has been done in the factory.

1) Make sure that other wireless equipment is turned off.

2) Tap on [Piano Assign] in the [PRC-100 Menu] screen.

3) Move the Pocket Controller close to the Disklavier,

and then tap on .

4) Tap on [OK] .

5) Tap on [OK] on the [Assigned successfully] screen.

The [PRC-100 Menu] screen resumes.

Note: Do NOT abort the procedure before step 4.

Otherwise you cannot control the Disklavier.

Resetting the Pocket Controller

When rebooting cannot be performed or the Pocket

Controller does not work correctly even after rebooting,

follow the procedure below.

1) Connect the AC adapter to the AC adaptor jack, and

then set the battery replacement switch to the

[REPLACE BATTERY] position.

2) Wait for five seconds, remove the battery compartment

lid, and then press the [RESET] button with the stylus pen.

3) Replace the battery compartment lid, and then set the

battery replacement switch back to the [NORMAL OPERA-

TION] position.

4) Press to turn the Pocket Controller on. The [Main] screen

appears after approximately two minutes.

MHB23 MKIV/PRO DIOV1.05, SCV.1.01 PAGE.18