Yamaha DM 2000 Version 2 Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Alat Musik Yamaha DM 2000 Version 2. Yamaha DM 2000 Version 2 14 halaman. Version 2
Juga untuk Yamaha DM 2000 Version 2: Panduan Pemilik (44 halaman), Panduan Instalasi (28 halaman), Panduan Instalasi (22 halaman), Panduan Instalasi Perangkat Lunak (13 halaman), Panduan Pemilik (1 halaman), Panduan Tambahan (4 halaman), Panduan Pemilik (37 halaman), Setup Manual (35 halaman), Panduan Orientasi (8 halaman), Manual Redundansi (8 halaman), Panduan Pemilik (3 halaman), Panduan pemasangan sistem operasi (Jerman) (13 halaman)

Halaman Cetak
Yamaha DM 2000 Version 2 Panduan Instalasi

Direct installation

If you can access the Internet directly from your computer,
follow the steps below to install the software. See page 7 if
you access the Internet from a different computer.
NOTE: The following instruction refers to the installation of the
software in the 02R96 from a connected computer that runs
Windows 98SE. However, the basic installation procedure also
applies to any OS or console. Steps that vary with different
operating systems will be explained separately.
NOTE: If an error message appears, refer to the Error Message
list on page 11.
1
Start the computer and check to see if the
following steps are complete.
• Installing the Yamaha USB-MIDI Driver in the
computer (See the included Studio Manager
Installation Guide.)
• Accessing the Internet from the computer
• The console's system software has been updated to
version 2.0 or later (You don't need to check this on
the PM5D).
NOTE: Don't connect your computer to the console yet.
2
While holding down the following key on the
console, turn on the power of the console.
Continue holding down the key until the display blinks
"FLASH UPDATE."
DM2000: Transport [REC] key
02R96: MACHINE CONTROL [REC] key
DM1000: MONITOR [CLEAR] key
01V96: SOLO [CLEAR] key
PM5D: SCENE MEMORY [RECALL] key
3
Make sure that the display indicates "FLASH
UPDATE," and then use a USB cable to connect
your computer to the console.
4
Insert the included CD-ROM into the CD-ROM
drive.
5
Locate the Upgrade folder on the CD-ROM
("Mac OS 9: Upgrade" for Mac OS 9; "Mac OS
X: Upgrade" for Mac OS X), then copy the
folder onto the hard disk.
6
Double-click "DMUpgrade.exe" (or
"AE***UpgradeE" for Mac OS) in the Upgrade
folder that you copied to the hard disk.
The installer window opens.
7
Select [Authorize], then click [Next].
The following window opens.
8
Select [Get access key from authentication
server], then click [Next].
The following window opens.
Add-On Effects Installation Guide
5