Yamaha Electone CSY-2A Manual - Halaman 10
Jelajahi secara online atau unduh pdf Manual untuk Alat Musik Yamaha Electone CSY-2A. Yamaha Electone CSY-2A 24 halaman. With synthesizer
Juga untuk Yamaha Electone CSY-2A: Panduan Pengguna (24 halaman), Manual (24 halaman)
Halaman CetakPreset Tone
Your CSY-2A has 14 preset tone levers on the front panel.
When you depress one of the levers and push a note, you
hear the sound of the instrument voice identified by name
on the lever panel.
It is designed to create the sound of
only one instrument at a time.
Note:
If you
depress more than one preset tone lever at the same
time, you
hear only the instrument
selected
by the lever
furthest to the right on the panel.
When no levers are de-
pressed, you hear no synthesized voices.
Tuning
To tune the synthesizer section of the CSY-2A with the
Electone
or another
instrument, wait about fifteen min-
utes after it is turned on. Then push down the Flute preset
and the vibrato
lever to the "control" position, and slide
the vibrato depth control to the "minimum" position to
eliminate the vibrato. Slide the "tuning control" (at the
extreme left of the panel) to the left (flat) or right (sharp)
until you obtain the right pitch; the pitch can be increased
or lowered about 100 cents (one semitone) in relation to
the standard pitch. To easily obtain proper pitch, match
the Flute
preset with
the 8° Flute tone
lever on the
Electone portion of the CSY-2A.
Transposition
On the front panel, to the right of the preset tones, there
are four transposition levers.
These levers shift the syn-
thesized voices up one or two octaves, or down one octave.
When you depress two or more transposition levers at the
same time, you hear only the one furthest to the right on
the panel.
When no transposition lever is depressed, you
hear the keyboard as if the "normal" transposition lever
was depressed.
The synthesizer section of the CSY-2A is designed to sound
one note at a time; if you depress more than one key at
the same time, you will always hear the highest note.
The volume of the synthesized voices is affected by the
expression pedal.
Filter
Simply stated, a filter alters the harmonics contained in a
note to change its color or timbre.
Each of the preset
tones has as a design feature the characteristic harmonic
structure
and
resonant
points that
identify
a particular
instrument.
Switch the filter to manual control by putting
the filter lever in the "control" position (down).
You can now control the filter characteristics (from low-
pass to highpass, and degree of resonance) with the cutoff
frequency and resonance controls.