Yamaha PORTATONE PSR-500M Panduan Pemilik - Halaman 34
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Alat Musik Yamaha PORTATONE PSR-500M. Yamaha PORTATONE PSR-500M 46 halaman.
Halaman Cetak
FEATURE REFERENCE (miny
RECEIVE
RECEIVE CH7
CLOCK
@ RECEIVE CHANNEL/CLOCK
The enable/disable status of all MIDI receive channels
is set via the MIDI section RECEIVE CH./CLOCK [A]
and [W] buttons. The [À] button increments the receive
channel number shown on the display and the [V] button
decrements the receive channel number. The receive chan-
nel number is shown on the right two digits of the MULTI
DISPLAY while the status — "E" for enabled or "d" for
disabled — appears on the leftmost digit. The MIDI chan-
nel and status display appears while selection is in
progress and for approximately 2 seconds after both MIDI
CH. buttons are released. A "C" in place of the channel
number (1 through 16) stands for "CLOCK," and allows
reception of the MIDI clock to turned on or off. If the
[RECEIVE ON/OFF] button is used while the MIDI re-
ceive channel or clock display is showing, the status of the
channel or clock can be switched between "E" and "d."
* Receive channel/clock settings apply to both the Remote Control
and Multi Voice receive modes.
* Separate receive channel/clock settings are retained in each
PAGE MEMORY even when the power is turned off (see "PAGE
MEMORY" on page 14 for details).
32
€ MODE
The [MODE] button is used to select the MIDI rec fi.
mode in which the PSR-500M is to operate — Remote
Control or Multi Voice.
Press the [MODE] button to call the mode display, then
use the same button to select "00" (Remote Control) or
"99" (Multi Voice).
STYLE /SPUT VOCE
МОС
STYLE! SPLIT vow
MODE
ч
rn
ec
"тиыш
uj
00-ВЕМОТЕ
СЕ
99-MULTI
STYLE — SPLIT VOCE
Bi
STYLE — SPLITVOICE
м
* The MIDI MODE is automatically reset to "00" whenever the
power is turned on, when a different PAGE MEMORY is se-
lected, or when the DEMO function is used.
Ш The Remote Control Mode (Mode 00)
The Remote Control mode should be used when the
PSR-500M is to be connected to a second keyboard by
which it is to be controlled. In this mode playing the ар -
nal keyboard has exactly the same effect as playing i
PSR-500M's own keyboard. Further the PSR-500M panel
controls can be used as normal. This mode is automati-
cally selected whenever the PSR-SOOM is turned on, when
a different PAGE MEMORY is selected, or when the
DEMO function is used.
Data Received In the Remote Control Mode
The PSR-500M receives and responds to the following
data received via the MIDI IN connector when the Remote
Control mode is selected:
* n addition to note and velocity data, the PSR-500M ге-
sponds to program change, sustain ON/OFF, vibrato,
volume, pan, reverb, start, stop, and MIDI clock mes-
sages.
* Program change messages 00 through 99 correspond to
voices 00 through 99.
* See page 34 for details on control change messages.