Yamaha TP-7300Rseries Panduan Pemilik - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Alat Musik Yamaha TP-7300Rseries. Yamaha TP-7300Rseries 14 halaman. Pedal timpani

Halaman Cetak

Take your foot off the pedal.

• Heel still moves up

g Repeat steps

• Heel stays down

g Go to step

Put your foot on the pedal and fully depress it

in either direction (toe and heel).

• Toe and heel feel equal

g Go to step

• Heel feels lighter than toe (*)

g Head is too tight and should be loosened.

Keeping the heel of the pedal depressed,

loosen the first tension rod by 1/2 turn and

then re-tighten it by 1/4 of a turn. Perform

this operation for all other tension rods in

the order shown in step

Repeat this procedure until proper head

tension is obtained then go to step

• Heel feels heavier than toe

g Head is not tight enough. Keeping the

heel end of the pedal depressed, tighten

each of the tension rods another 1/8 (45°)

turn in the same order as in step

Repeat this procedure until proper head

tension is obtained then go to step

through

Move the pedal into an intermediate position,

as shown below, and remove your foot from the

pedal. Confirm that the pedal stays in this posi-

tion and does not move.

• If the pedal remains in the same position

adjustment is complete. Go to step

• If the toe of the pedal moves downward

g The head is too tight. Loosen the head us-

ing the procedure described in step

Tap the head lightly with the mallet.

The standard striking point is shown below.

Striking point

Pedal

As the toe of the pedal is pressed down, the

pitch is raised.

For details on precise tuning refer to "Adjusting

the Pitch" on the following page.

As the head will stretch over time, read-

justment should be performed periodi-

cally (starting with step

Initial Preparation

(*).

The standard striking

point lies at distance B

from the bearing edge,

which corresponds ap-

proximately to 1/4 to 1/3

of the distance between

the bearing edge and

the center of the head.