Yamaha TP3323 Panduan Pemilik - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Alat Musik Yamaha TP3323. Yamaha TP3323 12 halaman. Tp3300 series pedal timpani

Halaman Cetak

1. Pedal Adjustment

Put your foot on the pedal and fully depress it in

either direction (toe and heel).

• Toe and heel feel equal

→ Go to step

• Heel feels lighter than toe (*1)

→ Head is too tight and should be loosened.

Keeping the heel of the pedal depressed,

loosen the first tuning bolt by 1/2 turn and

then re-tighten it by 1/4 of a turn. Perform

this operation for all other tuning bolts in

the order shown in step

Repeat this procedure until proper head

tension is obtained then go to step

• Heel feels heavier than toe

→ Head is not tight enough. Keeping the

heel end of the pedal depressed, tighten

each of the tuning bolts another 1/8 (45°)

turn in the same order as in step

Repeat this procedure until proper head

tension is obtained then go to step

Move the pedal into an intermediate position,

as shown below, and remove your foot from the

pedal. Confirm that the pedal stays in this posi-

tion and does not move.

• If the pedal remains in the same position

adjustment is complete. Go to step

• If the toe of the pedal moves downward

→ The head is too tight. Loosen the head

using the procedure described in step

(*1).

For details on precise tuning refer to "Adjusting the

Pitch" on the following page.

Tap the head lightly with the mallet.

The standard striking point is shown below.

Striking point

Pedal

As the toe of the pedal is pressed down, the pitch

is raised.

As the head will stretch over time, readjust-

ment should be performed periodically (start-

ing with step

Initial Preparation

The standard striking

point lies at distance B

from the kettle edge,

which corresponds

approximately to 1/4 to

1/3 of the distance

between the kettle

edge and the center of

the head.