Yamaha YVN500S Panduan Pemilik - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Alat Musik Yamaha YVN500S. Yamaha YVN500S 10 halaman. Violin

Before Playing the Instrument

■ About the Bridge

The instrument is shipped from the workshop with its bridge properly set and aligned on

the instrument's top.

After confirming that the bridge is in proper alignment, tune the instrument.

• Four notches in the bridge provide proper spacing between the strings.

Make sure that each string is set in its corresponding groove as shown in the illustration

below.

• Using the notches in the left and right side f holes as a guide, refer to the diagram below

and make sure that the bridge is properly positioned. If the bridge is not properly posi-

tioned, place the instrument on a stable surface, slightly loosen the strings, then gently

position the bridge using both hands. Also, make sure that each string is set in its groove.

[On the YVN100G/200G/500G]

The center of the bridge should be aligned

with a line running between the two f hole

notches that face the center of the violin.

Bridge

Caution

•

To obtain the best tone quality and performance from the YVN100S/200S/500S, it

is important that the bridge is properly set as shown in the diagram above. Refer

to the illustrations above when adjusting the bridge.

Groove

4th string

[Looking from the tailpiece]

Bridge

" f "

hole

1st string

[On the YVN100S/200S/500S]

The side of the bridge with the trademark

(the side facing the tailpiece, the vertical

side) should be aligned with a line running

between the two f hole notches that face

the center of the violin.

Bridge

Body top

Bridge

" f "

hole