Yamaha YX500FT Panduan Pemilik - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Alat Musik Yamaha YX500FT. Yamaha YX500FT 8 halaman. Multi-frame parts, xylophone
Halaman Cetak
First, assemble the Multi-Frame (RD500) then attach the xylophone set (YX500FT) onto the frame.
For safety reasons, make sure that assembly of the Multi-Frame and attaching of the instrument is
carried out with two or more persons, and that you assemble the product in an area with adequate
space.
1
Fully insert the end of stay C with its notch facing up into the joint on
leg base A , then fi rmly tighten the wing bolt.
* Pay attention to the stay's orientation when attaching. Parts are marked with
letters to assist with assembly. (Refer to the diagram below.)
2
Remove the wing nut, washers, and spring washers on the center rail
of the bass side leg base A , slide the C-shaped end of the diagonal
stay support C onto the bolt on the center rail then tighten the wing
nut fi rmly with washer and spring washer.
3
Use the same procedure to connect the clamp and diagonal stay
support on stay C to the center rail on the treble side leg base B .
4
Loosen the clamp screws on both ends of the rack pipe D and fasten
the clamps onto the poles on the upper leg section.
The rack pipe can be attached so its clamp side is either on the
audience side or the player's side of the pole. Decide how much space
you need between the rack pipe and tone bars and attach the rack
pipe accordingly.
* Please make sure that the YAMAHA logo is not placed upside-down.
5
Firmly tighten all bolts.
Assembly of the Multi-Frame is complete.
When disassembling the multi-percussion rack, follow the
assembly steps in reverse order.
Rack frame
6
2
1
※
A
Leg base
Match "Y"
Assembly
4
D
Rack pipe
Center rail
C
Stay
※
Match "Z"
4
6
3
3
B
Leg base
1,3
Wing bolt
A
B
(
)
Leg base
Notch
C
Stay
2,3
Wingnut
Tighten
Spring washer
Washer
A
B
(
)
Center rail
C
Diagonal stay support
4
A
(
B
)
Rack frame
Pole
Tighten
D
Rack pipe
D
Rack pipe
D
Rack pipe
11