Yamaha Arius YDP-S51 Panduan Pemilik - Halaman 28

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Papan Ketik Elektronik Yamaha Arius YDP-S51. Yamaha Arius YDP-S51 37 halaman. Owner's manual
Juga untuk Yamaha Arius YDP-S51: Panduan Pengoperasian Cepat (2 halaman), Panduan Referensi (8 halaman)

Halaman Cetak

Appendix

Keyboard Stand Assembly

CAUTION

• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance

with the sequence given below.

• Assembly should be carried out by at least two persons.

• Assemble the unit on a hard and flat floor with ample space.

• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.

• Be sure to tighten up all screws upon completing assembly of each unit.

• To disassemble, reverse the assembly sequence given below.

Have a Phillips-head (+) screwdriver of the

appropriate size ready.

Remove all parts from the package and make sure you

have all of the items.

Bundled pedal cord inside

* The two anti-fall brackets are identical. (Either one can be

used for left or right.)

* The adaptor may not be included, or may look different from

the illustration above, depending on your particular area.

Please check with your Yamaha dealer.

Assembly Parts

1 6 x 25 mm long screws x 4

2 6 x 20 mm long screws x 2

3 6 x 16 mm short screws x 4

4 4 x 12 mm thin screws x 2

YDP-S51 Owner's Manual

AC Power adaptor

5 4 x 20 mm tapping

screws x 2

6 Caps x 2

7 Cord holders x 2

8 Anti-fall brackets x 2

Attach (finger-tighten) C to D and E.

1-1 Untie and straighten out the bundled cord. Don't

discard the vinyl tie. You will need it later in step 6.

1-2 Align D and E with each end of C.

1-3 Attach D and E to C by finger-tightening the long

screws 2 (6 x 20 mm).

1-3

Attach B.

2-1 Attach the top of B to D and E by finger-tightening

the thin screws

(4 x 12 mm).

2-2 While pressing on the lower part of D and E from

the outside, attach the anti-fall brackets and then

secure the bottom ends of B using four long

screws

(6 x 25 mm).

2-3 Insert the other two tapping screws

into the other two screw holes to secure B.

1-2

(4 x 20 mm)