Yamaha ARIUS YDP-S55 Panduan Pemilik - Halaman 34

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Papan Ketik Elektronik Yamaha ARIUS YDP-S55. Yamaha ARIUS YDP-S55 48 halaman.
Juga untuk Yamaha ARIUS YDP-S55: Panduan Pengoperasian Cepat (2 halaman), Referensi Midi (4 halaman)

Yamaha ARIUS YDP-S55 Panduan Pemilik
Keyboard Stand Assembly

YDP-165, YDP-145 Assembly

You can watch a video of the assembly.
Scan the QR code at left or access the
website below.
https://4wrd.it/ydp_assembly_video1
Check if you have all of the items indicated below.
NOTICE
Make sure to place the main unit on the polystyrene foam
pads that have been removed from the packages. Position the
pads so that they will not contact the speaker covers on the
bottom of the main unit.
Speaker cover
Polystyrene foam pads
Cord holder
Side board (L)
× 4
Flat head screws (6 × 20 mm)
× 2
Thin screws (4 × 12 mm)
× 4
Thick screws (6 × 16 mm)
YDP-165
AC adaptor
Headphone hanger set
Headphone hanger
* The adaptor may not be included, or may look different from the
illustration above, depending on your particular area.
34
YDP-165, YDP-145, YDP-S55, YDP-S35 Owner's Manual
Main unit
Speaker cover
Back board
Pedal box
Side board (R)
× 4
Caps
× 4
Tapping screws
(4 × 20 mm)
YDP-145
Power cord
AC adaptor
× 2
Screws
(4 × 10 mm)
1.
Align the side boards with each end
of pedal box, and lightly tighten
with flat head screws (6 × 20 mm)
for temporary fastening
These screws will be tightened securely later in
step 3.
Side board (R)
Pedal box
× 4
Flat head screws (6 × 20 mm)
2.
Attach the back board.
Depending on the model, the surface color of one
side of the back board may be different from the
other side. In this case, position the back board so
that the side facing the front (pedal side) matches
the color of the main unit.
2-1
Place the back board on each foot of side
boards.
2-2
Attach the top of the back board by
temporarily fastening the thin screws (4 ×
12 mm).
2-3
While pushing on the lower part of the side
boards from the outside, secure the bottom
ends of the back board using tapping screws
(4 × 20 mm) in the order from outside to
inside (
).
1
2
Side board (L)