Yamaha A-S500 Panduan Pemilik - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Yamaha A-S500. Yamaha A-S500 42 halaman. Integrated amplifier
Juga untuk Yamaha A-S500: Panduan Pemilik (22 halaman), Panduan Pemilik (20 halaman), Panduan Pemilik (38 halaman)

Halaman Cetak

■ Adjusting the BASS and TREBLE

controls

The BASS and TREBLE controls adjust high and low

frequency response.

The center position produces a flat response.

BASS

When you feel there is not enough bass (low frequency

sound), rotate clockwise to boost. When you feel there is

too much bass, rotate counterclockwise to suppress.

Control range: –10 dB to +10 dB (20 Hz)

TREBLE

When you feel there is not enough treble (high frequency

sound), rotate clockwise to boost. When you feel there is

too much treble, rotate counterclockwise to suppress.

Control range: –10 dB to +10 dB (20 kHz)

■ Adjusting the BALANCE control

The BALANCE control adjusts the sound output balance

of the left and right speakers to compensate for sound

imbalance caused by speaker locations or listening room

conditions.

■ Adjusting the LOUDNESS control

Retain a full tonal range at any volume level, thus

compensating for the human ears' loss of sensitivity to

high and low-frequency ranges at low volume.

CAUTION

If the PURE DIRECT switch is turned on with the

LOUDNESS control set at a certain level, the input signals

bypass the LOUDNESS control, resulting in a sudden

increase in the sound output level. To prevent your ears or

the speakers from being damaged, be sure to press PURE

DIRECT switch AFTER lowering the sound output level

or AFTER checking that the LOUDNESS control is

properly set.

Set the LOUDNESS control to the FLAT

position.

Rotate the VOLUME control on the front

panel (or press VOLUME +/– buttons on the

remote control) to set the sound output level

to the loudest listening level that you would

listen to.

Rotate the LOUDNESS control until the

desired volume is obtained.

After setting the LOUDNESS control, enjoy listening to music at

your preferred volume level. If the effect of the

control setting is too strong or weak, readjust the LOUDNESS

control.

Recording a source

Notes

• The audio signals are not output via the LINE 2 REC or LINE 3

REC output jacks when LINE 2 or LINE 3 is selected with the

REC OUT selector.

• This unit must be turned on in order to record.

• The VOLUME, BASS, TREBLE, BALANCE and

LOUDNESS controls and the PURE DIRECT switch have no

effect on the source being recorded.

• Check the copyright laws in your country before recording from

records, CDs, radio, etc. Recording copyright-protected

material may infringe on copyright laws.

Rotate the REC OUT selector on the front

panel to select the source you want to

record.

Play the source and begin recording using

the recording device connected to the REC

output jacks (LINE 2 and/or LINE 3) on the

rear panel. See page 5.

While recording, you can select another input source using the

INPUT selector or the remote control and listen to another input

source without affecting recording.

LOUDNESS

PLAYING AND RECORDING

REC OUT