Yamaha BBT 500H Panduan Pemilik - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Yamaha BBT 500H. Yamaha BBT 500H 21 halaman. Yamaha bass amplifier owner's manual
Juga untuk Yamaha BBT 500H: Daftar Tambalan Preset (1 halaman), Manual (Belanda) (21 halaman)

Halaman Cetak

Panel Controls and Connections

Rear Panel

Outboard Effects Processor

Tuner

!4 Tuner Output (TUNER OUT)

This output jack is used to connect a tuner to the BBT500H.

It can also be used to create a bi-amp system. Connect this output jack

to the INPUT jack on another BBT500H. (

!5 Effect Loop (FX LOOP)

• Effect Send Jack (SEND)

• Effect Return Jack (RETURN)

• Effect Loop Level Switch (LEVEL)

These jacks let you insert an outboard effects processor between the

SEND and RETURN jacks to apply effects to the BBT500H's signal.

Use the Level Switch to match the Input/Output level with the level re-

quired by the outboard effects processor. Use the BLEND control in the

Compressor Mode to adjust the balance level between the outboard

effector's sound and the sound that is created by the BBT500H. (

13)

!6 Headphones Jack (PHONES)

This jack is used to connect a pair of headphones to the unit. It carries

the same signal that is delivered from the LINE OUT jack. Use the LEVEL

control to adjust the volume.

!7 Headphones/Line Out Level Control (LEVEL)

Adjusts the output level of the PHONES jack and the LINE OUT jacks.

(The same setting is applied to both jacks.)

Before making any connections, make sure that the power on

the BBT500H and all other related devices is switched OFF.

Mixer or Additional Amplifier

Headphones

OUT

!6 !7

Clamp Filter (

pg. 17)

* For U.S. and Canadian

models only

pg. 14)

Save patches to a

Speaker(s)

!8 Line Out Jack (UNBALANCED OUT, BALANCED OUT)

These jacks carry the signal that is selected with the !9 Line Out Source

Switch at a line level.

Both unbalanced phone type (+4 dB/10 k ) and balanced XLR type

(+4 dB/600 ) jacks are provided.

Use the LINE SOURCE switch to select the signal that is sent to the

LINE OUT jack. As the unit is equipped with an output limiter and speaker

simulator (can be switched ON/OFF), and the output level of these jacks

is controlled by the LEVEL control, these jacks can be used to send a

line level signal to a mixing console or an additional amplifier.

!9 Line Out Source Switch

(LINE SOURCE: THRU/PRE EQ/POST EQ)

This switch is used to select the signal that is delivered from the LINE

OUT jack.

pg.

THRU ........... Delivers the signal received via the INPUT jack without

PRE EQ ....... Delivers the signal before it has been processed by the

POST EQ ..... Delivers the signal after it has been processed by the

Use a MIDI controller to select

MIDI device

patch memory

STATUS

BANK MSB/MAX

8. 8 . 8

DATA/CTRL

BANK LSB/MIN

TOGGLE ON-OFF

/NUMBER OF PGM

DEC

INC

MEMORY

/NO

/YES

EDIT

MIDI OUT

MIDI IN

Supplied power

cable

AC Power

alteration.

Select this setting when connecting to a DI (Direct In-

jection) box.

tone controls (the Sound Type is active).

This setting can be used when separate EQ settings

are required for speaker and line outputs.

tone controls.

WRITE

EDIT

/EXIT