Yamaha CX-A5000 Setup Manual - Halaman 6

Jelajahi secara online atau unduh pdf Setup Manual untuk Penguat Yamaha CX-A5000. Yamaha CX-A5000 43 halaman. Av pre-amplifier
Juga untuk Yamaha CX-A5000: Setup Manual (7 halaman), Manual (8 halaman), Contoh Koneksi (2 halaman)

Halaman Cetak

Use the cursor keys to select

"Save/Cancel" and press ENTER.

Use the cursor keys to select "SAVE" and

press ENTER.

Disconnect the YPAO microphone from the

unit.

This completes optimization of the speaker settings.

• The YPAO microphone is sensitive to heat, so should not be

placed anywhere where it could be exposed to direct sunlight or

high temperatures (such as on top of AV equipment).

If "W-1:Out of Phase" appears

Follow the procedure below to check the speaker

connections.

When you have made balanced connections

• The XLR balanced jacks of your power amplifier may not be

compatible with the pin assignments of the unit. In this case,

turn off the power amplifier, change its pin assignment setting

or use unbalanced connections, and then try YPAO

measurement again.

a Use the cursor keys to select "Result" and press ENTER.

b Use the cursor keys to select "Wiring".

c Check the cable connections (+/–) of the speaker that

was identified as being "Reverse" in the warning

message.

If the speaker is connected correctly:

Depending on the type of speakers or room

environment, this message may appear even if the

speakers are connected correctly.

In this case, you can ignore the message.

Press RETURN and proceed to step 3.

If the speaker is connected incorrectly:

Turn off the unit, reconnect the speaker cable, and then

try YPAO measurement again.