Yamaha KAX-5000 Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Yamaha KAX-5000. Yamaha KAX-5000 16 halaman. Owner's manual

Halaman Cetak

Controls and Functions

■ Front Panel

1 POWER switch and indicator

Press to toggle the power on or off. The POWER indicator

lights up green when the power is ON.

2 TEMP indicator

Lights up red if the heat sink temperature exceeds 85°C

(185°F).

3 PROTECTION indicator

Lights up red to indicate that protection is in effect. Specifi-

cally, lights up if the heat sink overheats, or if a DC voltage is

detected at the amplifier outputs. Also lights up for about three

seconds at time of power-on, as the amp gets ready to operate.

To provide protection, the unit will not output any sound from

the speakers while this indicator is lit up. When start-up is

completed or the problem is corrected, the indicator goes off

and normal operation resumes.

4 CLIP indicator

Lights up red when the output signal distortion on the corre-

sponding channel rises above 1%—indicating that "clipping"

has occurred because the signal level is too high.

5 SIGNAL indicator

Lights up green when the corresponding channel

exceeds 2 Vrms (equivalent to 1/2 W into an 8 Ω load, or 1 W

into a 4 Ω load).

6 Volume control knobs

Each control knob adjusts the volume of the corresponding

channel, in 31 steps from –∞ dB to 0 dB.

NOTE:

If you wish to lock in the knob settings, you can fasten the sup-

plied security cover over the knobs so that the settings will not

be disturbed.

s output level

How to install the security cover

(1) Use the supplied hex wrench to remove the four attach-

ment screws from the amplifier.

(2) Adjust the security cover to the position of screw holes.

Fasten it into place using the same screws.

indicator

Lights up yellow if the YS PROCESSING switch on the rear

panel is set ON. (See page 7.)

8 Air intakes

The amplifier uses forced-air cooling. The cooling fans draw

air in from the front and exhaust it through the rear. Please be

sure that you do not block the air intakes or exhaust vents.

NOTE:

The fans do not come on at initial power-on, but will switch on

automatically when the temperature of the heat sink rises above

50°C (122°F). The fan speed will then vary automatically as

the temperature changes.