Yamaha ATS-2070 Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pembicara Yamaha ATS-2070. Yamaha ATS-2070 42 halaman. Front surround system
Juga untuk Yamaha ATS-2070: Manual Pembaruan (7 halaman), Panduan Pemilik (46 halaman), Panduan Servis (50 halaman)

Halaman Cetak

If you notice any abnormality

• If any of the following abnormalities occur, immediately turn off the power and

disconnect the power plug.

- The power cord/plug is damaged.

- An unusual smell or smoke is emitted from the unit.

- Foreign material gets into the interior of the unit.

- There is a loss of sound during use.

- There is a crack or damage in the unit.

Continued use could cause electric shocks, a fire, or malfunctions. Immediately

request an inspection or repair from the dealer where you purchased the unit or

from qualified Yamaha service personnel.

• Be careful not to drop or apply strong impact to this unit. If you suspect the unit may

have been damaged due to dropping or impact, immediately turn off the power and

pull the power plug from the AC outlet. Failure to observe this may cause electric

shocks, a fire, or malfunctions. Immediately request an inspection from the dealer

where you purchased the unit or from qualified Yamaha service personnel.

CAUTION

This content indicates "risk of injury."

Power supply/power cord

• Do not use an AC outlet where the power plug fits loosely when inserted. Failure to

observe this may cause a fire, electric shocks, or burns.

• When removing the electric plug from the unit or an AC outlet, always hold the plug

itself and not the cord. Pulling by the cord can damage it and cause electric shocks

or a fire.

• Insert the power plug firmly all the way into the AC outlet. Using the unit when it is

not plugged in sufficiently can cause dust to accumulate on the plug, causing a fire

or burns.

Installation

• Do not place the unit in an unstable position where it might accidentally drop or fall

over and cause injuries.

• Do not block this unit's ventilation holes (cooling slits). This unit has ventilation

holes on the bottom to prevent the internal temperature from becoming too high.

Failure to observe this may trap heat inside the unit, causing a fire or malfunctions.

• When installing this unit:

- Do not cover it with any cloth.

- Do not install it on a carpet or rug.

- Make sure the top surface faces up; do not install on its sides or upside down.

- Do not use the device in a confined, poorly-ventilated location.

Failure to observe the above may trap heat inside the unit, causing a fire or

malfunctions. Ensure that there is adequate space around the unit: at least 10 cm

(4 in) on top, 10 cm (4 in) on the sides, and 10 cm (4 in) on the rear.

• Do not place the unit in a location where it may come into contact with corrosive

gases or salt air or places that have excessive smoke or steam. Doing so may

result in malfunction.

• Avoid being near the unit during a disaster, such as an earthquake. Since the unit

may turn over or fall and cause injury, quickly move away from the unit and go to a

safe place.

• Before moving this unit, be sure to turn off the power switch and disconnect all

connection cables. Failure to observe this may damage the cables or cause you or

someone else to trip and fall.

• Be sure to request that the dealer where you purchased the unit or qualified service