Yamaha C115VA Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Pembicara Yamaha C115VA. Yamaha C115VA 11 halaman. Speaker system and subwoofer
Juga untuk Yamaha C115VA: Panduan Pemilik (11 halaman), Panduan Pemilik (37 halaman), Panduan Pemilik (11 halaman)

Halaman Cetak

1. Connecting the Speakers

Suspended and Bracket Installation

• Consult an installation expert to arrange for installation or construction work.

• Choose suspension wire, an installation location, and mounting hardware that are strong enough to support the

weight of the speaker.

• Some ﬁttings may deteriorate over extended periods of time due to wear or corrosion. For safety the installation

should be checked thoroughly at regular intervals.

Yamaha cannot be held responsible for damage or injury caused by insufﬁcient strength of the support structure or improper

installation.

I Suspended Installation

The C112VA and C115VA can be used in suspended "ﬂying"

rigs by using an appropriate suspension wire.

1. Replace the bolts with the supplied eyebolts (3/8") as shown

in the diagram, and then suspend the speaker using an

appropriate wire.

Bolts

Eyebolts

• Use only the supplied eyebolts.

• Use two or more eyebolts for suspended installa-

tion. Always use the eyebolts marked

• Do not suspend a speaker from another suspended

speaker.

2. The speaker angle can be adjusted for optimum coverage by

adjusting the lengths of the suspension wires, but the down-

ward tilt angle must be less than 45 degrees, as shown in the

diagram.

Bolts

Eyebolts

Maximum

45 Degrees

I Bracket Installation

The C112VA has bracket-mounting screws on the top, bottom,

and sides of the speaker enclosure. The C112VA can be

mounted on a wall or ceiling using the optional brackets listed

below.

Wall bracket

Ceiling bracket

Baton bracket

Bracket

Model

BWS251-300, BWS251-400

BCS251

BBS251

• Use only the speciﬁed screws (W5/16")

to attach the bracket to the speaker.

The mounting screws are installed on the speaker

when it leaves the factory. Refer to the instruc-

tion manual supplied with your bracket for

installation details.

Screws (W5/16")