Directechs DB3 Panduan Instalasi - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Mobil Directechs DB3. Directechs DB3 20 halaman. 2011 subaru outback - 403.subaru2 1.25
Juga untuk Directechs DB3: Panduan Instalasi (19 halaman), Panduan Instalasi (19 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (10 halaman), Buku Petunjuk (17 halaman)
Halaman Cetak
Pre-installation and application warnings
Firmware notes: This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
The optional Plug & Play THFD1 T-Harness is sold separately and is NOT compatible with 2016+ Ford Focus RS or 2017+
Ford Escape.
The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.
The T-Harness can be used for multiple vehicle installation and there is it important to connect ONLY the specific wires
associated with your vehicle. Refer to the "Wiring diagram with T-Harness" and follow the diagram connections.
Key2GO is required if only one key is available. You can program the interface without the need for Key2GO if two keys
are present.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
Refer to the "Vehicle connections" following the installation diagram.
General notes: This section highlights important information for this specific firmware.
Tach wire is an optional connection required on some remote starters, which do NOT support a tach signal in D2D.
[1]
On vehicles WITHOUT one-touch window controls, both Unlock 1 and Unlock 2 wires need to be connected to wake up
[2]
the BCM from sleep mode.
The Trunk Release/Power Liftgate connection is ONLY required on the 2013-2015 Escape. The 2016 Ford Escape Power
[3]
Liftgate is in Data.
5
403.FORD4 3.13 2016 Ford Transit Connect
© 2018-07-11 Directed. All rights reserved.
THFD1
Keys required for
1
Keys required for
programming
operation
0