Directechs DB3 Buku Petunjuk - Halaman 14
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Aksesori Mobil Directechs DB3. Directechs DB3 17 halaman. 2011 subaru outback - 403.subaru2 1.25
Juga untuk Directechs DB3: Panduan Instalasi (20 halaman), Panduan Instalasi (19 halaman), Panduan Instalasi (19 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (10 halaman)
Halaman Cetak
Parking light error codes
The parking lights on your vehicle will flash a specific number of times 3 seconds following an unscheduled shutdown. Each flashing pattern
is described below.
Flashes
Diagnostic
1
Runtime expired.
2
Over-rev shutdown.
3
Low or no RPM.
4
Shutdown without remote.
5
Brake shutdown.
6
Hood shutdown/Remote start safety override switch is ON.*
7
Remote start safety override switch is ON.*
* If the vehicle hood status is supported through data, the safety override switch input will report 7 flashes.
Soft reset
A module reset will only erase the steps perfomed in "Module Programming". The firmware and settings flashed to the module will not be
affected.
Connect the 10-pin & 12-pin harnesses to the module. Press and hold the programming
1
button, then connect the 14-pin harness to the module.
Wait 3 seconds until the LED turns ON solid orange then release the programming button.
2
The LED turns ON solid red.
Hard reset
Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default factory settings. Depending on the installation, some settings may need to be
reconfigured. Connect your module to a computer and use the web configuration tool to edit its programmable features.
Connect the 10-pin & 12-pin harnesses to the module.
1
Press and hold the programming button, then connect the 14-pin harness to the
module.
Wait 3 seconds until the LED turns ON solid orange, and wait 10 more seconds until the
2
LED starts to flash orange and red.
3
Release the programming button. The LED turns ON solid red.
14
403.MA3 2.42.104 2014 Mazda 3 (Smart Key)
©2023 Directed. All rights
3
rd
1
st
(Button)
(10-pin)
&
Solid
Release
3
rd
1
st
(Button)
(10-pin)
Solid
Release
2
nd
4
th
(12-pin)
(14-pin)
&
Solid
2
nd
4
th
(12-pin)
(14-pin)
&
Flashes
&
Solid