Yamaha YSP-5600 Panduan Referensi Cepat - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Referensi Cepat untuk Sistem Pembicara Yamaha YSP-5600. Yamaha YSP-5600 19 halaman.
Juga untuk Yamaha YSP-5600: Panduan Pembaruan Firmware (3 halaman)

Halaman Cetak

■ Notes on remote controls and batteries

• Do not spill water or other liquids on the remote control.

• Do not drop the remote control.

• Do not leave or store the remote control in the following conditions:

– places of high humidity, such as near a bath

– places of high temperatures, such as near a heater or stove

– places of extremely low temperatures

– dusty places

• Insert the battery according to the polarity markings (+ and -).

• Change all batteries if you notice the following conditions:

– the operation range of the remote control narrows

• If the batteries run out, immediately remove them from the remote control to prevent an explosion or

acid leak.

• If you find leaking batteries, discard the batteries immediately, taking care not to touch the leaked

material. If the leaked material comes into contact with your skin or gets into your eyes or mouth,

rinse it away immediately and consult a doctor. Clean the battery compartment thoroughly before

installing new batteries.

• Do not use old batteries together with new ones. This may shorten the life of the new batteries or

cause old batteries to leak.

• Do not use different types of batteries (such as alkaline and manganese batteries) together. Danger of

explosion may happen if batteries are incorrectly replaced. Specification of batteries may be different

even though they look the same.

• Before inserting new batteries, wipe the compartment clean.

• Keep batteries away from children. If a battery is accidentally swallowed, contact your doctor

immediately.

• When not planning to use the remote control for long periods of time, remove the batteries from the

remote control.

• Do not charge or disassemble the supplied batteries.

Information for Users on Collection and Disposal of Old

Equipment and Used Batteries

These symbols on the products, packaging, and/or accompanying documents mean that

used electrical and electronic products and batteries should not be mixed with general

household waste.

For proper treatment, recovery and recycling of old products and used batteries, please

take them to applicable collection points, in accordance with your national legislation

and the Directives 2002/96/EC and 2006/66/EC.

By disposing of these products and batteries correctly, you will help to save valuable

resources and prevent any potential negative effects on human health and the

environment which could otherwise arise from inappropriate waste handling.

For more information about collection and recycling of old products and batteries,

please contact your local municipality, your waste disposal service or the point of sale

where you purchased the items.

[Information on Disposal in other Countries outside the European

Union]

These symbols are only valid in the European Union. If you wish to discard these items,

please contact your local authorities or dealer and ask for the correct method of disposal.

Note for the battery symbol (bottom two symbol examples):

This symbol might be used in combination with a chemical symbol. In this case it

complies with the requirement set by the Directive for the chemical involved.

■ For U.K. customers

If the socket outlets in the home are not suitable for the plug supplied with this appliance, it

should be cut off and an appropriate 3 pin plug fitted. For details, refer to the instructions

described below.

Note

The plug severed from the mains lead must be destroyed, as a plug with bared flexible cord is

hazardous if engaged in a live socket outlet.

■ Special Instructions for U.K. Model

IMPORTANT

THE WIRES IN MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE

FOLLOWING CODE:

Blue: NEUTRAL

Brown: LIVE

As the colours of the wires in the mains lead of this apparatus may not correspond with the

coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured BLUE must be connected to the terminal which is marked with the

letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the

terminal which is marked with the letter L or coloured RED.

Making sure that neither core is connected to the earth terminal of the three pin plug.

To view the Owner's Manual, click on "English" in the screen displayed automatically when you

insert the CD-ROM into your PC, or click on the model name if the screen to select models is

displayed, and then click on "English" in the next screen. Then, follow the onscreen instructions.

If the screen is not displayed automatically, open the "index.html" in the CD-ROM.

The Owner's Manual contained in the CD-ROM can be downloaded from the following website:

URL : http://download.yamaha.com/