Directed 403.TL10 Panduan Instalasi - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Mobil Directed 403.TL10. Directed 403.TL10 19 halaman.

Halaman Cetak
Directed 403.TL10 Panduan Instalasi

Feature and option list

It is recommended to configure all the features and options listed below using the configuration tool found on the module flashing page at
www.directechs.com. The web offers more options; however, manual configuration of the features is possible using the information on this
page.
* Default option
Feat
Operation
Flashes / Option
.
1. No RF Output*
1
RFTD Output Type
2. RFTD Output
3. SmartStart
1. Driver priority*
2
Unlock Driver Priority
2. All
1. Trunk*
3
Trunk
2. Right Sliding Door
3. Left Sliding Door
1. Trunk
4
Aux1
2. Right Sliding
Door*
3. Left Sliding Door
1. Trunk
5
Aux2
2. Right Sliding Door
3. Left Sliding
Door*
1. Disabled
6
Smart OEM Alarm
Control
2. Safelock
3. Enabled*
7
16
403.TL10 2.29 2017 Toyota Camry (H Key)
©2022 VOXX•DEI LLC. All rights reserved.
Description
Module is connected to a remote starter using a standard installation.
Module is connected to an XL202 using an RSR or RXT installation (when available).
Module is connected to SmartStart using an RSR or RXT installation (when available).
Unlocks only the driver door when the button is first pressed, and unlocks all doors when it is pressed a second
time within 5 seconds.
Unlocks all doors when the button is first pressed.
Will pop the trunk if available.
When available, will operate the right sliding door.
When available, will operate the left sliding door.
Will pop the trunk if available.
When available, will operate the right sliding door.
When available, will operate the left sliding door.
Will pop the trunk if available.
When available, will operate the right sliding door.
When available, will operate the left sliding door.
The OEM alarm will not be controlled by the interface upon remote start. No disarm or arm command will be
executed at the beginning or end of the sequence; it must be controlled by the Remote Starter.
Smart OEM Alarm Control will behave like a standard Safelock feature on a remote starter. It will unlock at the
beginning of the sequence, and relock after start and shutdown.
Smart OEM Alarm Control will synchronize with the OEM alarm so that it will disarm and rearm the vehicle in the
remote start sequence, only when required. Smart OEM Alarm Control will monitor the alarm and door lock
status to detect if the disarm or rearm is required. If the vehicle is unlocked or is not equipped with factory alarm,
the disarm/rearm will not be executed.