Clark Synthesis TST209 Panduan Instalasi - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Transduser Clark Synthesis TST209. Clark Synthesis TST209 16 halaman.
Halaman Cetak
Installation Type: T-Nut
Requires initial access to the top of the material to insert
the T-Nut, which installs flush to the surface. (Drill a 7/16"
hole for the T-Nut.)
Minimum 3-1/2" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
3/4"-thick
mounting
surface
Flat Washer
Lock Washer
Transducer Lead Wire
www.clarksynthesis.com
Drill 7/16" hole
T-Nut
NEVER TIGHTEN
BY TURNING THE
Jam Nut (up)
TRANSDUCER.
MAKE SURE TO
3/8"-16
TIGHTEN THE JAM
Threaded Stud
NUT AGAINST THE
Jam Nut (down)
TRANSDUCER'S
BRASS NUT
Washers
Jam Nuts
INSTALLATION: OVERVIEW
Installation Type: Hex Bolt
For use with metal or other high-tensile mounting surfaces
no thicker than 1/4". Requires access to the top of the
mounting surface both to install the bolt and to tighten it.
Minimum 3-1/4" vertical space required,
including 1/2" clearance between the
Transducer and the floor.
Maximum
1/4"-thick mounting
surface
Lock Washer
Drill 7/16" hole
3/8"-16
Hex Bolt
Flat Washer
Jam Nut (up)
Jam Nut (down)
Transducer Lead Wire
Flat Washer
Lock Washer
Jam Nuts
TST209 Transducer
7