Clark Synthesis Diluvio Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pembicara Clark Synthesis Diluvio. Clark Synthesis Diluvio 4 halaman. Underwater loudspeaker installed in a hayward face rim

Halaman Cetak

Diluvio™ INSTALL- HAYWARD FACE RIM

Diluvio™

Remove the

cm) of the sound lens rubber ring (see Photo #1 below). DO NOT CUT the rubber ring that holds the

speaker wire. Next, remove the screw, nut, and washer from the assembly clamp (#2). Carefully spread the

assembly clamp so it can go around the sound lens rubber ring. Place the assembly clamp around the sound

lens rubber ring leaving the 1 inch (2.54 cm) gap in the rubber ring exposed (#3). Reinstall the screw, nut

, and washer in the assembly clamp (#4).

Carefully place the Hayward face rim (chrome side down) on a non-abrasive surface, and place the speaker

and assembly clamp on the Hayward face rim (#5). Align the assembly clamp screw so that it does not

cover the mounting tab or the face rim lockscrew. Once aligned, tighten the assembly clamp screw until

the speaker is securely attached to the face rim (#6). Do not overtighten. The gap in the rubber ring will

be reduced.

Underwater Speaker- Hayward

Loudspeaker from its box. Using a pair of wire cutters, carefully remove 1 inch (2.54

Page 2 of 4