Directed Directechs MIT6 Panduan Instalasi - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Mobil Directed Directechs MIT6. Directed Directechs MIT6 19 halaman.

Module programming

Refer to "LED diagnostics and troubleshooting" on page 13 for more information and for troubleshooting purposes.

To connect the module:

Please ensure that the vehicle is in a safe location and cannot move forward during

programming. For vehicles equipped with a manual transmission, make sure the gearshift

lever is in the neutral position.

Connect all the harnesses to the Directed Digital Solutions, EXCEPT the 12-pin main power

harness.

Connect the 12-pin main power harness, and wait until the LED turns ON solid red.

Turn the ignition ON using the key.

The LED flashes green then turn ON green for 3 seconds and shuts OFF.

Turn vehicle ignition OFF once the module is successfully programmed.

Pair remotes (if applicable). For information on how to pair a specific remote, please

refer to its corresponding owner documentation, which can be found inside the product

packaging of the complete system or on www.directechs.com.*

DATA Tach: Firmware using DATA Tach, the tachometer is preprogrammed for the

vehicle and no further action is required. For instructions on how to adjust tach or use

Virtual tach, see page 16 (not needed with hardwired or data tach applications).

Hardwire Tach: Firmware using the Violet/White Hardwire Tach input will require

programming. For instructions on how to program or adjust tach or use Virtual tach, see

page 16 (not needed with hardwired or data tach applications).

* Your aftermarket remote may differ from the model shown in the illustrations.

You have successfully completed the module programming sequence.

Connect all but the

12-pin harness

Must be connected LAST

Key OUT

Key IN

START

Flashes

Solid

x3 sec

Key OUT

remotes*

Initialize

tachometer

Directed Digital Solutions MIT6

Solid

Key IN

START

Off

Key IN

START

Pair