Clark-Reliance Simpliport 180 Panduan Petunjuk Pemasangan, Pengoperasian & Pemeliharaan - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan, Pengoperasian & Pemeliharaan untuk Kelistrikan Industri Clark-Reliance Simpliport 180. Clark-Reliance Simpliport 180 8 halaman.

Halaman Cetak

The Reliance

Simpliport

has been designed to accept 120VAC or 240 VAC

power sources and for a service life of up to 7 years.

The LED Illuminators are weatherproof and are

rated safe for use in ordinary locations

STORAGE and HANDLING

All units should be inspected upon receipt to ensure

that no damage has been incurred during transit. If

there is a claim due to damage, it should be filed

with the carrier immediately. Units should be stored

in a dry and sheltered area prior to installation, in a

secure manner where they can neither fall, nor be

struck by other objects. The temperature of the

storage area should not exceed 170 F. (75 C.)

COMPONENTS

There are five main components that make up the

Simpliport Illuminator Assembly: the LED

Illuminator, the front end hood, the mounting bar

assembly, the power supply, and the cable

connecting the power supply to the LED

Illuminator. The cable may have more than one

piece depending on the required distance between

the Illuminator and the power supply. In most cases,

however, the power supply will be mounted directly

to the LED Illuminator.

INSTALLATION

CAUTION: All LED Illuminators are

tagged with the service conditions for that

particular unit. This information is located on

the power supply housing. The ratings should be

reviewed prior to installation and again prior to

start-up, to ensure proper operation in the

installed environment.

IMPORTANT

Never remove the blue cord between the power

supply and illuminator while power is applied.

Doing so will cause permanent damage to the

LEDs.

16633 Foltz Parkway

180 LED Illuminator

Strongsville, OH 44149 USA Telephone: +1 (440) 572-1500

www.clark-reliance.com

Note: All installation steps should be performed

by a qualified technician and should be executed

in accordance with all applicable national and

local codes.

The LED Illuminator and power supply should

be checked to ensure that they contain no foreign

matter, and that the end connections are clean,

undamaged, and in line with existing conduit.

Step by step instructions:

1) Assemble the mounting bar assemblies to the

Simpliport Gage mounting lugs using the (4)

5/16" X 1" SHCS that are provided (Fig. 1).

2) To mount the LED Illuminator assembly to

the gage: While holding the illuminator at a

slight angle, slide illuminator top onto pins.

Align bottom pins with slots and rest unit in

place. Note: The Simpliport

viewed with the packing nuts facing

slightly to the left. Make sure the

Illuminator and viewing hood are in the

correct orientation to the Simpliport

Gage. (Fig. 2)

3) Repeat the procedure in Step 2 to mount the

front end hood to the opposite side (viewing

side) of the gage.

4) The unit's power supply has wire leads and a

fuse ready to connect to the incoming AC

power source. Remove the enclosure lid to

access wiring. Connect incoming AC power

source per local and National Electric Codes.

The fused (red) wire is to be connected is the

"Hot" and the remaining white wire is the

"common".

5) The power supply can be remote mounted if

desired. After remote mounting of power

supply, if the blue power cord will not reach

the power supply, contact your local

representative.

[email protected]

Gage must be

Fax: +1 (440) 238-8828