Directed Xpresskit DBALL2 Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Mobil Directed Xpresskit DBALL2. Directed Xpresskit DBALL2 11 halaman. Ford5 remote start ready (rsr) installation
Juga untuk Directed Xpresskit DBALL2: Panduan Instalasi (12 halaman), Panduan Instalasi (19 halaman), Panduan Instalasi (18 halaman), Manual (14 halaman), Panduan Instalasi (13 halaman), Panduan Instalasi (14 halaman), Panduan Instalasi (19 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (15 halaman), Panduan Instalasi dan Referensi Cepat (16 halaman), Panduan Instalasi (18 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (18 halaman), Panduan Instalasi (16 halaman), Manual (19 halaman), Panduan Instalasi (10 halaman)

Halaman Cetak

Directed Xpresskit DBALL2 Panduan Instalasi

Platform: DBALL/DBALL2

Firmware: HK2

Module Programming

Refer to the LED Diagnostics section on pages 8-9 for more information and for troubleshooting purposes.

Important

Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to

ensure everything is correct prior to moving onto the next step.

Warning!

To take advantage of advanced features, you must use XpressVIP 4.5 (and higher) or the Directechs Mobile app.

Flashing a module using your computer:

1. Connect the interface module to your computer using the

XKLoader2.

2. Go to www.directechs.com using Internet Explorer, and

select the Flash Module button.

3. Follow the instructions to select your vehicle, installation

type, and configure your options.

4. Once you have configured the firmware options, click on the

FLASH button.

When the flashing operation is successful, you can proceed with the programming instructions below.

D2D Installation

If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to

the module, then connect the 4-pin D2D harness.

W2W Installation

If required for your installation, connect the 10-pin and 12-pin harnesses to the

module, then connect the 14-pin harness to the module.

Wait until the LED turns ON solid red.

Note: To skip the transponder programming and use convenience

feature only, press the programming button 5 times. The LED will

turn orange then proceed to step 4.

Turn the key to the ON position.

The LED will flash green then solid green for 3 seconds, and then

turns OFF.

If the vehicle doesn't have a transponder, the LED will remain

solid red. Press the programming button 5 times to skip the

transponder programming.

The LED turns ON solid orange for 3 seconds then shuts off when

programming is done.

Turn the key to the OFF position and remove it from the ignition.

You have successfully completed the module programming sequence.

Flashing a module using your smartphone or tablet

1. Connect the interface module to your XKLoader3.

2. Launch the Directechs Mobile app on your smartphone or

tablet.

3. Select FLASH YOUR MODULE and follow the on screen

instructions.

Key IN

Rev.: 20160829

START

Flash

Green

3 seconds

Press

Solid Red

Orange

Off

3 seconds

Key OUT

START

Page 5

Solid

Off