Directed Xpresskit DBALL2 Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Mobil Directed Xpresskit DBALL2. Directed Xpresskit DBALL2 10 halaman. Ford5 remote start ready (rsr) installation
Juga untuk Directed Xpresskit DBALL2: Panduan Instalasi (12 halaman), Panduan Instalasi (19 halaman), Panduan Instalasi (18 halaman), Manual (14 halaman), Panduan Instalasi (13 halaman), Panduan Instalasi (14 halaman), Panduan Instalasi (19 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (15 halaman), Panduan Instalasi dan Referensi Cepat (16 halaman), Panduan Instalasi (18 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (18 halaman), Panduan Instalasi (16 halaman), Manual (19 halaman), Panduan Instalasi (11 halaman)

Halaman Cetak
Directed Xpresskit DBALL2 Panduan Instalasi
Platform: DBALL2
Firmware: REN11

Module Programming

Refer to the LED Diagnostics section of this guide for more information and for troubleshooting purposes.
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning!
To take advantage of advanced features, you must use XpressVIP 4.5 or higher. Using version 2.9 or 3.1 will limit
available functions and features.
1. Connect the interface module to your computer using the XKLoader2.
2. Open an Internet Explorer browser (version 6 or higher), and go to www.xpresskit.com. The detail of the platform and firmware
that is currently saved on the interface module will be indicated in the top left corner of the page.
3. Select the year, make and model of the vehicle; the page will refresh to display the compatible firmware.
4. In the search result page, select one of the available install options (config for RSR, RXT or Standard install), and follow the
instructions provided on the screen.
5. Once you have configured your options, click on the FLASH button to upload the firmware onto the interface module.
6. The following message will be displayed when the upload is completed:
"The flashing is successfully completed. You may now unplug the kit."
You can now proceed with the programming instructions below.
1
Wait until the LED turns ON solid red.
Press PTS twice to turn ignition ON. The LED will turn
2
ON solid green for 3 seconds, then shuts OFF.
3
Having all doors close press lock and unlock button from OEM remote.
4
The LED turns ON solid green for 3 seconds, then turns OFF
once the module has been successfully programmed.

Feature Programming

No feature programming are available for this firmware.
Refer to the LED Diagnostics section on page 6 for more information and for troubleshooting purposes.
ENGINE
&
2X
PUSH
START
STOP
&
Solid Green
x3 secs
© 2022 Directed. All rights reserved.
Rev.: 20230129
Page 5
Solid
Flashes
OFF