Clarke 3110380 Petunjuk Pengoperasian & Pemeliharaan - Halaman 6
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Alat Listrik Clarke 3110380. Clarke 3110380 11 halaman. Air stapler
Halaman Cetak
MAINTENANCE
Daily before use.
1.
Drain water from compressor air tank, and air line.
2.
Check and clean, if necessary, the air inlet gauze filter.
3.
A bottle of CLARKE Air Line Oil** is supplied with the kit. Squirt a few drops of oil
(approx. 3cc), into the air inlet.
This should be carried out regardless of whether or not an air line lubricator is
used.
During Use
.
For lubricating the internal components when in operation, an air line lubricator
should be used, with Clarke Air Line Oil**, adjusted to 2 drops per minute.
If an Air line lubricator is NOT used, this procedure should be repeated after every
two to three hours of use.
Storage.
If the Stapler is to be stored, or is idle for longer than 24 hours, run a few drops of
Clarke Air Line Oil* into the air inlet before storing.
Notes
Be aware that factors other than the tool may effect its operation and efficiency
such as reduced compressor output, excessive drain on the airline, moisture or
restrictions in the line, or the use of connectors of improper size or poor condition
which will reduce air supply.
Grit or gum deposits in the tool may also reduce efficiency. This condition can be
corrected by cleaning the air strainer and flushing out the tool with gum solvent
oil, or failing this, the tool should be disassembled, thoroughly cleaned, dried and
reassembled.
If the tool runs erratically or becomes inefficient, and the air supply is sound,
dismantle the piston assembly and replace worn or damaged parts, or take the
tool to your CLARKE dealer.
**Clarke Air Line Oil is available from your CLARKE dealer part no. 3050825.
The use of parts other than CLARKE replacement parts may result in safely
hazards, decreased tool performance and will invalidate your warranty.
IMPORTANT:
6