Clarke 3110463 Petunjuk Pengoperasian & Pemeliharaan - Halaman 10

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Alat Listrik Clarke 3110463. Clarke 3110463 17 halaman. Air nibbler

CHANGING THE PUNCH AND DIE

1. Loosen the locknut using a 22mm

spanner and unscrew the die (with

the locknut on it) from the body of

the tool.

2. Place a 9mm spanner onto the

hex section of the die collar as

shown and undo/remove the die

collar and punch.

3. Remove the old punch from the

collar and insert the new one.

4. Screw the collar and punch back

into place and tighten with the

spanner.

5. Slide the die and locknut over the

punch and screw it back into the nibbler until the bottom of the punch is

flush with the bottom of the die. Rotate the die into the best position

required by the workpiece. Hold the die steady with a 15mm spanner on its

flats and re-tighten the locknut.

STORAGE

If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of

Clarke air-line oil into the air inlet, and depress the trigger in order to lubricate

the internal parts.

When not in use, disconnect from air supply, clean and store in a safe, dry

place.

ACCESSORIES

A wide range of airline accessories is available including filter/regulators,

lubricators, high-pressure hoses (5 to 50 metres) etc.

Contact your Clarke dealer or Clarke International Service Department for

further information.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]