Clarke 3110565 Petunjuk Pengoperasian & Pemeliharaan - Halaman 7

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Alat Listrik Clarke 3110565. Clarke 3110565 13 halaman. Needle scaler

Halaman Cetak

The first position, achieved by turning the body and the retaining lug

anticlockwise, creates the greatest needle force, the second position,

achieved by pushing harder against spring pressure and turning the body

clockwise, creates a slightly lesser

manner, creates even less. A position should be selected depending upon your

requirements, dictated by the finish required and the type of material being worked.

A gauze filter is fitted within the air inlet adapter. Ensure this filter is always in

place and clean. An air line is connected to the adapter, preferably via a

quick release coupling (not supplied).

Ensure the operating lever is NOT depressed when connecting the air line.

USING THE TOOL

Hold the tool with the fingers of one hand wrapped around the operating

lever, and bring towards the work at an angle of approx.60-70

airline pressure set to 90 lbf/in

needles to come into contact with the work.

Moving slowly across the work surface, proceed to remove scale, rust or other

contaminants.

Release the trigger to stop operation, noting that the tool may impact briefly

after the trigger is released.

DISCONNECTING THE AIR SUPPLY

1. Do not disconnect the air supply hose until the compressor has been shut

down and the compressed air released.

2. Refer to the compressor instruction manual for the procedure to shut down

and vent the compressed air.

3. Once the pressure has been released, disconnect the air supply hose from

the air tool.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

force, and the third position, achieved in a similar

(6.1bar), pull the operating lever and allow the

. With the