Clarke 3110847 Petunjuk Pengoperasian & Pemeliharaan - Halaman 8
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Alat Listrik Clarke 3110847. Clarke 3110847 17 halaman. Air ratchet wrench
Juga untuk Clarke 3110847: Panduan Petunjuk Pengoperasian & Pemeliharaan (8 halaman)
Halaman Cetak
OPERATION
USING THE DIRECTION CONTROL
WARNING: ALWAYS WAIT UNTIL THE DRIVE SHAFT HAS STOPPED ROTATING
BEFORE OPERATING THE DIRECTION CONTROL.
To select the direction of rotation turn
the direction control as follows.
• For tightening, turn the direction
control anti-clockwise to F
(Forward).
• For loosening, turn the direction
control clockwise to R (Reverse).
USING THE AIR RATCHET
1. Select the socket you require.
• Push the socket onto the square
drive shaft. It clicks into place
when secure.
2. Place the socket over the nut.
• Take care that the socket is
firmly engaged.
3. Squeeze the trigger against the
body of the tool to start.
4. Release the trigger to stop the tool.
5. Always ensure the tool has stopped before putting it down.
6. When releasing very tight fastenings initially break loose by hand. Squeeze
the trigger and the air tool will complete the job.
7. If necessary, use penetrating oil to assist in freeing off rusted fasteners.
8. When assembling, start turning fasteners by hand, then set the rotation
forward or reverse. Apply the tool gently and squeeze the trigger to tighten
with power.
9. Final tightening should be completed by hand.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8