Clarke 3400764 Petunjuk Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Alat Listrik Clarke 3400764. Clarke 3400764 13 halaman. Hot air gun

OPERATION

Before starting work it is recommended that you heat a test piece to ensure

you have the correct heat setting. In addition you should always take steps to

protect sensitive or delicate areas where the effect of heat could cause

damage (i.e. glass and plastics). Do not apply heat to the same place for a

long time.

After the work has been completed, switch the gun off, disconnect from the

mains supply and allow to cool in a safe place.

Take care not to drop the gun as this could damage the heating element.

To prevent the gun from overheating, maintain a minimum distance of 3 cm

between the end of the nozzle and the work piece.

1. Fit the nozzle to the front of the gun.

2. With the switch in the '0' (OFF) position plug the gun into the mains supply.

3. Set the switch to either position 1

or 2 according to how much heat

is required. (see Specification).

• Ensure the nozzle is pointing

away from you.

4. Bring the nozzle of the hot air gun

to the work piece approximately 3

cm from the surface.

• The exact distance between

the nozzle and the work piece

will be dependent on the material being worked on.

• Paint will rapidly become soft and blister, at which point it can be

removed with the triangular shave hook. Do not allow paint to burn

as this will make the removal process more difficult.

• Most adhesives dissolve when heated and these can then be

removed, taking care that any parts from which glue is removed are

heat resistant.

• Heating and paint removal are performed simultaneously, with the

shave hook following the hot air gun.

5. Clean the shavehook blade quickly if paint/glue becomes stuck to it.

• Profiled parts may be cleaned with a suitable wire brush once paint

is softened.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]