Clarke 6462180 Panduan Petunjuk Pengoperasian & Pemeliharaan - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian & Pemeliharaan untuk Alat Listrik Clarke 6462180. Clarke 6462180 17 halaman.

2. Adjust the pendulum control to

suit the material being cut using

the following suggested settings

as a starting point if required.

NOTE: Do not use the pendulum

action for cutting ceramics or

metals.

• Ceramics

• Metal

• Plywood, plastics

• Timber, fibreboard & chipboard 1-3

CUTTING DIFFERENT MATERIALS

CUTTING WOOD

Check that any previously used timber being sawn does not contain any nails

or other metal objects which would damage the blade.

CUTTING METAL

Having chosen a suitable blade for cutting metal it is recommended to

lubricate the material and blade with cutting oil to prevent the tool from

overheating. Support the workpiece with wooden blocks on either side.

ADJUSTING THE SOLE PLATE

The sole-plate is adjustable so that bevels of up to 45° may be cut. Loosen the

two socket head screws under the sole-plate before adjusting it to the desired

angle and re-tightening the screws.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

1-2