Clarke BJ300 Petunjuk Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Alat Listrik Clarke BJ300. Clarke BJ300 17 halaman. Biscuit jointer
Halaman Cetak
OPERATION CONTINUED
MAKING MITRE JOINTS
NOTE: Always unplug the biscuit jointer before making any adjustments.
1.
Using a combination square draw a
reference mark 'A' through the
centre point of each joint
perpendicular to the mitred edge 'B'.
2.
Follow the cutting instructions (2-14) for
edge to edge jointing on page 8.
MAKING BUTT JOINTS
1.
Position the mating pieces together
and draw a reference mark 'A' at 90°
to the centre point of each proposed
joint location 'B',.
2.
Follow the cutting instructions (2-14) for
edge to edge jointing on page 8.
MAKING CORNER JOINTS
1.
Position the pieces together and draw a reference line on the outside face of
one piece and the end of the second piece.
2.
Follow the cutting instructions (2-11)
on page 8 and cut a slot into
the end of piece 'A'.
3.
Clamp piece 'B' that it protrudes
above your work bench.
4.
Without changing any of the settings
on the jointer. Follow the cutting
instructions (5-14) on page 8 and cut
a slot into the face of piece 'B'.
A
B
A
B
A
- 9 -
B