Clarke Metalworker CL251MH Petunjuk Pengoperasian & Pemeliharaan - Halaman 8
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Alat Listrik Clarke Metalworker CL251MH. Clarke Metalworker CL251MH 16 halaman. Metalworker milling/drilling attachment
Halaman Cetak
ASSEMBLY
Ensure the power supply to the lathe is disconnected.
If any accessories are attached to the cross slide of the lathe, they must be removed
before fitting the Mill/Drill Head.
Slacken the Tailstock securing bolts and slide it to the end of the bed and secure in
this position.
Bolt the Mill/Drill to the Metal Lathe as shown in Fig. 2, using the four hex. socket
head bolts supplied, ensuring they are tight.
Attach the Head Control Wheel Handle,
'A', and the Spindle Lowering Lever, 'B',
securing the latter with the single screw,
provided.
Finally bolt on the plastic guard, 'C'
ensuring the metal block (arrowed) is
between the head and the guard,
tightening the two securing screws using
the hex key provided, (with the lathe).
Finally, plug the Power Cable into the socket on the rear of the Lathe Headstock.
8
Fig. 2
Fig. 3