Clarke PRO237 Petunjuk Pengoperasian & Pemeliharaan - Halaman 7
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Alat Listrik Clarke PRO237. Clarke PRO237 12 halaman. Digital torque wrench
Halaman Cetak
PREPARATION FOR USE
INSTALLING THE BATTERIES
1. Open the cover of the battery
compartment by turning it anti-
clockwise & insert four AAA batteries
as shown. Close the compartment
cover and the wrench is ready to use.
TURNING THE WRENCH ON /OFF
1. Press the
• The unit will bleep and the complete
display screen will momentarily light up.
2. Press the
TURNING THE DISPLAY ILLUMINATION ON/OFF
1. The display illumination can be turned on or off by pressing the
button.
AUTO POWER-OFF SETTING
When enabled, this setting means that the wrench will turn off automatically if
no buttons are pressed during a given time. Change the
follows:
1. Once the unit is powered up, press
Auto/Off time of
2. Press the
to turn off the Auto-Off function.
3. Press the
the measurement mode.
Note; If no buttons are touched for 3 seconds the wrench will return to
the measurement mode.
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
button to turn on.
button again to turn the system off.
5
(5 minutes) is shown on the display.
button to select the shut-off time of 5 or 15 minutes, or OFF
button to confirm the selection. The wrench will return to
three times and the default
7
Auto/Off
setting as